Installing The Front And Back Sled Covers - Dell PowerEdge C8000 Hardware Owner's Manual

Figure 3-25. Removing and Installing the Front Cover
1 screws (4)

Installing the Front and Back Sled Covers

NOTE:
It is recommended that you always use a static mat and static strap while
working on components in the interior of the system.
1 Check that all cable connections are secure.
2 Place the front cover on top of the sled tray, aligning the notches in the
front cover with the corresponding tabs in the sled tray. See Figure 3-25.
3 If an expansion card is installed, make sure the expansion card riser is
firmly seated.
4 If a hard-drive backplane is installed, connect all cables to the backplane
and proceed to next step.
5 Replace the four screws securing the front cover. See Figure 3-25.
6 Connect all cables to the hard-drive backplane and press down on the
locking tab to secure the cables. For sled without add-on cards, see
Figure 3-22. For sled with add-on cards, see Figure 3-23 or Figure 3-24.
7 Align the notches in the back cover with the corresponding tabs in the sled
tray.
2 front cover
Installing System Components
165