Sled
CAUTION:
To ensure proper airflow in the system, if a sled module is removed it
should be immediately replaced with another sled or sled blank.
CAUTION:
Operating the system for extended periods of time without a sled blank
installed can cause the PowerEdge C8000 server enclosure to overheat. See
"Installing a Sled Blank" on page 143.
Removing a Sled
1 Power down the sled using OS commands or the Baseboard Management
Controller, and ensure that the sled's power is off.
When a sled is powered off, its front-panel power indicator is off. See
Figure 3-6.
2 Press the release latch and using the handle, slide the sled out of the
chassis.
Figure 3-6. Removing and Installing a Sled
1
handle
2
release latch
Installing System Components
141