Removing The Front Gpgpu Card Assembly - Dell PowerEdge C8000 Hardware Owner's Manual

Following is an example showing the replacement procedure of the NVIDIA
Tesla M2090 GPGPU cards.

Removing the Front GPGPU Card Assembly

CAUTION:
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized is not covered by
warranty. Read and follow the safety instructions that came with the product.
CAUTION:
card riser. Do not attempt to install expansion cards directly into the riser
connector on the system board.
1 Remove the sled from the enclosure. See "Removing a Sled" on page 141.
2 Open the sled. See "Removing the Sled Cover" on page 166.
3 Remove the four screws securing the top cover. See Figure 3-40.
4 Lift the top cover from the sled cover. See Figure 3-40.
Figure 3-40. Removing and Installing the Top Cover
1 top cover
188
Installing System Components
Many repairs may only be done by a certified service technician. You
Expansion cards can only be installed in the slots on the expansion
2 screws (4)