Drive Cage; Removing The 2.5-Inch Rear Drive Cage; Installing The 2.5-Inch Rear Drive Cage - Dell 7HT3R Installation And Service Manual

Drive cage

This is a service technician replaceable part only.

Removing the 2.5-inch rear drive cage

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. If required, remove the air
4. Remove the drives.
5. Disconnect the cables from the rear drive cage.
Steps
1. Using a Phillips #2 screwdriver, loosen the blue thumbscrew that secures the rear drive cage to the system.
2. Slide the rear drive cage towards the front of the chassis and lift it away from the system.
Figure 93. Removing the 2.5-inch rear drive cage
Next steps
Replace the 2.5-inch rear drive

Installing the 2.5-inch rear drive cage

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. If required, remove the air
4. Remove the drives.
5. Disconnect the cables from the rear drive cage.
94 Installing and removing system components
Safety instructions.
Before working inside your
shroud.
cage.
Safety instructions.
Before working inside your
shroud.
system.
system.