Installing a Hard-Drive Carrier on the Sled Tray
CAUTION:
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized is not covered by
warranty. Read and follow the safety instructions that came with the product.
1 Place the hard-drive carrier into the sled tray and slide into place. See
Figure 3-18.
2 Tighten the thumbscrew to secure the hard-drive carrier in place. See
Figure 3-18.
3 Close the sled. See "Installing the Front and Back Sled Covers" on
page 165 or "Installing the Sled Cover" on page 168.
4 Replace the sled. See "Installing a Sled" on page 142.
Removing a Hard-Drive From a Hard-Drive Carrier
CAUTION:
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized is not covered by
warranty. Read and follow the safety instructions that came with the product.
CAUTION:
have hard-drive blanks installed.
CAUTION:
configuration is not supported.
CAUTION:
the SAS/SATA backplane.
CAUTION:
swappable drive installation. See the documentation supplied with the operating
system.
1 Remove the four screws securing the hard-drive. See Figure 3-19.
2 Lift the hard-drive out of the hard-drive carrier. See Figure 3-19.
156
Installing System Components
Many repairs may only be done by a certified service technician. You
Many repairs may only be done by a certified service technician. You
To maintain proper system cooling, all empty hard-drive slots must
Combining SAS, SATA, and SSD hard-drives in the same sled
Use only hard-drives that have been tested and approved for use with
To prevent data loss, ensure that your operating system supports hot-