Figure 3-76. Removing and Installing the SD Card Reader Support Bracket
1
screws (2)
Installing the SD Card Reader Support Bracket
CAUTION:
Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized is not covered by
warranty. Read and follow the safety instructions that came with the product.
1 Align the SD card reader support bracket with the screw holes on the sled
tray. See Figure 3-76.
2 Replace the two screws securing the SD card reader support bracket. See
Figure 3-76.
3 Replace the SD card reader. See "Installing the SD Card Reader" on
page 239.
4 Replace the mezzanine card. See "Installing the SAS Mezzanine Card" on
page 229, "Installing the Infiniband Mezzanine Card" on page 232, or
"Installing the 10 GbE Mezzanine Card" on page 236.
5 Close the sled. See "Installing the Front and Back Sled Covers" on
page 165 or "Installing the Sled Cover" on page 168.
6 Replace the sled. See "Installing a Sled" on page 142.
2
SD card reader support bracket
Installing System Components
241