Figure 3-24. Removing and Installing a 4-Drive Bay Back Cover From a Sled with
Add-On Card
1
cable retaining clip
3
4-drive bay back cover
5
power cable on NPDB
7
hard-drive LED cable
4 Remove the four screws securing the front cover. See Figure 3-25.
5 If a hard-drive backplane is installed in the front cover, disconnect all
cables from the backplane before proceeding to next step.
6 Lift the cover from the sled tray. See Figure 3-25.
164
Installing System Components
2
mini-SAS cable
4
power cable on hard-drive backplane
6
screws (5)