5 In the Server screen, select Remote Access Configuration and press
<Enter>.
6 In the Remote Access Configuration screen, verify the following settings:
•
Remote Access: Enabled
•
Serial port number: COM2
•
Serial Port Mode: 115200 8,n,1
•
Flow Control: None
•
Redirection After BIOS POST: Always
•
Terminal Type: ANSI
See "Remote Access Configuration" on page 94 for details. Make sure the
last four options syncs with the host and client.
7 In the Server screen, select BMC LAN Configuration and press <Enter>.
8 In the BMC LAN Configuration screen, verify the following settings:
•
BMC LAN Port Configuration: Shared-NIC
•
BMC NIC IP Source: DHCP or Static (Use DHCP if your network
servers are using automatic assignment of IP addresses)
•
IP Address: 192.168.001.003
•
Subnet Mask: 255.255.255.000
•
Gateway Address: 000.000.000.000
See "Set BMC LAN Configuration" on page 93 for details. Make sure the
host and client are on the same network
9 Press <Esc> to return to the System Setup screen. Press <Esc> again,
and a message prompts you to save the changes.
Using the System Setup Program
61