Sd Card Reader; Removing The Sd Card Reader - Dell PowerEdge C8000 Hardware Owner's Manual

4 Replace the screw securing the mezzanine card bridge board to the
bracket. See Figure 3-72.
5 Lower the 10 GbE mezzanine card assembly to the sled tray. See
Figure 3-71.
6 Replace the two screws securing the 10 GbE mezzanine card assembly to
the sled tray. See Figure 3-71.
7 Close the sled. See "Installing the Front and Back Sled Covers" on
page 165 or "Installing the Sled Cover" on page 168.
8 Replace the sled. See "Installing a Sled" on page 142.

SD Card Reader

Removing the SD Card Reader

CAUTION:
Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized is not covered by
warranty. Read and follow the safety instructions that came with the product.
1 Remove the sled from the enclosure. See "Removing a Sled" on page 141.
2 Open the sled. See "Removing the Front and Back Sled Covers" on
page 161 or "Removing the Sled Cover" on page 166.
3 Remove the mezzanine card. See "Removing the SAS Mezzanine Card" on
page 223, "Removing the Infiniband Mezzanine Card" on page 229, or
"Removing the 10 GbE Mezzanine Card" on page 233.
4 If installed, remove the SD card. Locate the SD card slot in the SD card
reader and press inward on the card to release it from the slot and remove
the card. See Figure 3-74.
Installing System Components
237