Dell PowerEdge C8000 Hardware Owner's Manual page 257

6 Install the node power distribution board. See "Installing the Node Power
Distribution Board" on page 248.
7 Install the interposer extender to the new board. See "Installing the
Interposer Extender" on page 243.
8 Install the hard-drive tray. See "Removing the Hard-Drive Tray" on
page 158.
9 Install the internal hard-drives. See "Installing a Hard-Drive Carrier on the
Sled Tray" on page 156.
10 Install the SD card reader support bracket. See "Installing the SD Card
Reader Support Bracket" on page 241.
11 Install the SD card reader. See "Installing the SD Card Reader" on
page 239.
12 Transfer the processors to the new system board. See "Removing a
Processor" on page 215 and "Installing a Processor" on page 217.
13 Remove the memory modules and transfer them to the same locations on
the new board. See "Removing Memory Modules" on page 221 and
"Installing Memory Modules" on page 222.
14 Replace the cooling shroud. See "Installing the Cooling Shroud" on
page 211.
15 If applicable, install the mezzanine card. See "Installing the SAS
Mezzanine Card" on page 229, "Installing the Infiniband Mezzanine Card"
on page 232, or "Installing the 10 GbE Mezzanine Card" on page 236.
16 Install the expansion card. See "Installing the MegaRAID SAS 9268-8i
Card" on page 184.
17 Close the sled. See "Installing the Front and Back Sled Covers" on
page 165 or "Installing the Sled Cover" on page 168.
18 Replace the sled. See "Installing a Sled" on page 142.
Installing System Components
257