Dell PowerEdge C8000 Hardware Owner's Manual page 278

Table 5-1. System Board Jumper Settings
Item Jumper
2 NVRAM clear
3 ME firmware
recovery
4 BIOS recovery
5 Password enable
6 Power button
pass
278
Jumpers and Connectors
Setting
(default) The configuration settings are retained at
(default) The ME firmware recovery jumper is
(default) The BIOS recovery jumper is disabled.
(default) The password feature is enabled.
(default) The BMC triggers a power button signal.
Description
system boot.
The configuration settings are cleared at
the next system boot.
disabled.
The ME firmware recovery jumper
enables ME firmware recovery mode.
The BIOS recovery jumper enables the
BIOS flash memory special recovery
mode.
The password feature is disabled.
The power button passthrough signal is
triggered.