Dell PowerEdge C8000 Hardware Owner's Manual page 104

Table 2-1. D4 Token Table
Token Setup Option
011B SATA Port2
011C SATA Port2
011D SATA Port3
011E SATA Port3
011F SATA Port4
0120 SATA Port4
0121 SATA Port5
0122 SATA Port5
0135 Embedded SATA
Controller
0137 Embedded SATA
Controller
0138 Embedded SATA
Controller
0139 Embedded SATA
Controller
013E Memory
Remapping
(3GB~4GB)
104
Using the System Setup Program
(continued)
Description
Turns off the 3rd Serial ATA drive controller.
Enables BIOS support for the 3rd Serial ATA drive
controller (enabled if present, POST error appears if
not present).
Turns off the 4th Serial ATA drive controller.
Enables BIOS support for the 4th Serial ATA drive
controller (enabled if present, POST error appears if
not present).
Turns off the 5th Serial ATA drive controller.
Enables BIOS support for the 5th Serial ATA drive
controller (enabled if present, POST error appears if
not present).
Turns off the 6th Serial ATA drive controller.
Enables BIOS support for the 6th Serial ATA drive
controller (enabled if present, POST error appears if
not present).
Disables the SATA controller. This token applies to
the first onboard SATA controller.
Enables the SATA controller to run in IDE mode. Sets
the device class code as IDE and uses PCI IRQ
(referred as Native mode). This token applies to the
first onboard SATA controller.
Enables the SATA controller. Sets the device class
code as SATA and sets up the AHCI BARs and
registers. This token applies to the first onboard SATA
controller.
Enables the SATA controller. Sets the device class
code as RAID and executes the RAID Option ROM.
This token applies to the first onboard SATA
controller.
When disabled, memory remapping relocates memory
space behind PCI hole to the space above 4 GB.