Removing The Back Gpgpu Card Assembly - Dell PowerEdge C8000 Hardware Owner's Manual

4 Replace the four screws securing the GPGPU card assembly to the sled
cover. See Figure 3-43.
5 Place the air baffle into the sled cover aligning the holes on the air baffle
with the screw holes on the sled cover. See Figure 3-42.
6 Replace the two screws securing the air baffle to the sled cover. See
Figure 3-42.
7 Connect the power cables to the GPGPU card. Press down on the locking
tab to secure the power cables. See Figure 3-44 cable routing diagram.
8 If necessary, route the cables and secure the cables to the retaining clips.
9 Place the top cover into the sled cover. See Figure 3-40.
10 Replace the four screws securing the top cover. See Figure 3-40.
11 Close the sled. See "Installing the Sled Cover" on page 168.
12 Replace the sled. See "Installing a Sled" on page 142.

Removing the Back GPGPU Card Assembly

CAUTION:
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized is not covered by
warranty. Read and follow the safety instructions that came with the product.
CAUTION:
card riser. Do not attempt to install expansion cards directly into the riser
connector on the system board.
1 Remove the sled from the enclosure. See "Removing a Sled" on page 141.
2 Open the sled. See "Removing the Sled Cover" on page 166.
3 Remove the four screws securing the top cover. See Figure 3-40.
4 Lift the top cover from the sled cover. See Figure 3-40.
5 If necessary, release the cables from the retaining clips on the sled cover.
6 Press down the cable-locking tabs and disconnect the power cables from
the back GPGPU card. See Figure 3-45.
194
Installing System Components
Many repairs may only be done by a certified service technician. You
Expansion cards can only be installed in the slots on the expansion