Configure Mld Snooping Querier - NETGEAR MS510TX User Manual

This is the interface to which an external multicast router is connected.
7. From the VLAN ID menu, select the VLAN ID of which the interface must be a member.
8. From the Multicast Router menu, select Enable to enable the multicast router mode for the
VLAN (and therefore, for the multicast router interface).
By default, Disable is selected.
9. Click the Apply button.
Your settings are saved.

Configure MLD Snooping Querier

You can configure the settings for an MLD snooping querier.

To configure an MLD snooping querier:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see
The login window opens.
4. Enter the switch's password in the Password field.
The default password is password.
The System Information page displays.
5. Select Switching> Multicast > MLD Snooping > Querier Configuration.
The MLD Snooping Querier Configuration page displays. The page also shows the VLAN
IDs Enabled for MLD Snooping Querier section.
6. Configure the following settings:
• Querier Admin Mode. Enable or disable MLD snooping for the switch. The default is
Disable.
• Snooping Querier Address. Enter an IPv6 address that is used as the source
address in periodic MLD queries. This address is used when no address is configured
on the VLAN on which a query is sent. The supported IPv6 address formats are
x:x:x:x:x:x:x:x and x::x.
• MLD Version. This is a field with the fixed value 1, which indicates that MLDv1 is the
version that is used in periodic MLD queries.
• Query Interval (secs). Specify the time interval in seconds between periodic queries
sent by the snooping querier. The query interval must be a value in the range of 30 to
1800. The default value is 125.
Smart Managed Pro Switches MS510TX and MS510TXPP
Configure Switching
Access the Switch
145
on page 12.