Cannot Adjust Printhead - Canon imagePROGRAF iPF810 User Manual

Cannot adjust printhead.

The Printhead nozzles are clogged.
The Printhead cannot be aligned; highly transparent
lm is loaded.
The Printhead is installed crooked.
Borderless printng not possible. Paper stretched or
shrank.
The loaded roll has expanded or contracted due to
environmental conditions, making it wider or narrower
than the supported width for borderless printing.
Before borderless printing, move the blue platen switch.
The blue Switch on the platen was set to the side
opposite ● when a borderless print job was received.
Cause
Cause
Cause
Messages regarding printing or adjusment
Corrective Action
Execute Auto Head Adj. again, as follows.
1.
Press the Online button to clear the error.
2.
Print a test pattern to check the nozzles.
(→P.587)
3.
Clean the Printhead if the nozzles are clogged.
(→P.588)
4.
Execute Auto Head Adj. again.
(→P.554)
Press the Online button to clear the error.
We recommend using a type of paper that you often
use, other than lm, for Printhead adjustment.
(→P.554)
Straighten the Printhead as follows, and then execute
Auto Head Adj. again.
1.
Press the Online button to clear the error.
2.
Use Head Inc. Adj. to adjust the angle of
inclination of the Printhead.
(→P.558)
3.
Execute Auto Head Adj. again.
(→P.554)
Corrective Action
Hold down the Stop button for a second or more to
cancel printing.
Use each type of paper only where the recommended
environmental conditions are met. For details on
environmental conditions for various paper, see the
Paper Reference Guide.
(→P.125)
Corrective Action
Before borderless printing, set the blue Switch on the
platen to the ● side.
(→P.639)
Error Message 675