Other Maintenance; Preparing To Transfer The Printer - Canon imagePROGRAF iPF810 User Manual

Other Maintenance

Other Maintenance

Preparing to Transfer the Printer

To protect the internal parts in transit, always follow the steps below before transferring the printer to a new location.
Refer to the Setup Guide for details on packing the printer and installing it after transfer.
Important
•
Be sure to contact your Canon dealer before transferring the printer to a new location. Ink may leak and
damage the printer if you do not prepare the printer correctly and it is tipped or stood on end in transit.
Note
•
It is not possible to prepare the printer for transfer if the Display Screen requests Maintenance Cartridge
replacement or checking of the remaining capacity. Replace the Maintenance Cartridge before transfer
preparations. (→P.595)
•
Depending on the state of the printer, part replacement may be necessary when preparing to transfer
the printer (that is, when you execute the printer menu item to prepare for transfer).
•
Ink must be drained before Level 2 or Level 3 printer transfer, as described in the following table.
Prepare a Maintenance Cartridge in advance.
•
Always follow the instructions of the service representative when transferring the printer under Level 3
conditions.
Level
1 By truck
2 By plane
3 Tipping the printer or
holding it upright for
elevators or stairs
*1: The quantity of cartridges required depends on the capacity of the Maintenance Cartridge in use.
610 Maintenance
Shipping Method
(Example)
Lengthwise: 0°-30°
Rotation: 0°-10°
All directions: 0°-30°
Lengthwise: 0°-90°
Rotation: 0°-30°
Permitted Angle of Inclination
Required
Amount of Ink
Maintenance
to Dispose of
Cartridges(*1)
0 0 or 1
Approx. 200 1 or 2
ml
Approx. 700 2 or 3
ml