Rel Lever Is In Wrong Position; Rewinding Error; Media Take-Up Unit Ready; Turn On The Media Take-Up Unit - Canon imagePROGRAF iPF810 User Manual

Rel lever is in wrong position.

The Release Lever is up.

Rewinding error.

There is some foreign object near the Media Take-up
Unit sensor and the roll cannot be detected.
The Media Take-up Unit sensor is soiled and the roll
cannot be detected.
The roll is out of range of detection by the Media
Take-up Unit sensor.
The Media Take-up Unit sensor is damaged.
A paper jam has occurred and the roll cannot be
rewound.
*Printing will stop momentarily if an error involving the Media Take-up Unit occurs. If you prefer printing not
to stop, set Skip Take-Up Err to On.

Media take-up unit ready.

The Take-up Reel setting in the printer MAIN MENU
was changed from Enable to Disable, but a print job
was received before the roll was removed.

Turn on the media take-up unit.

The Media Take-up Unit was off when you selected
Enable for Take-up Reel.
Cause
Cause
Cause
Cause
Corrective Action
Lower the Release Lever.
If the error occurs again, turn off the printer and wait
a while before restoring power.
Corrective Action
Remove the foreign object near the sensor.
Wipe the sensor with a dry cloth to clean it.
Reload the roll.
(→P.139)
Contact your Canon dealer for assistance.
Remove the paper from the Media Take-up Unit.
Press the Online button to clear the error.
Corrective Action
Press the Stop button and stop printing.
The mode switches from take-up mode to regular
mode after you change the Take-up Reel setting in
the MAIN MENU from Enable to Disable and lift the
Release Lever, or after you execute Paper Cutting.
Press the Online button to resume printing.
Corrective Action
Turn the Media Take-up Unit on.
Messages regarding paper
Error Message 669