Paper Size Not Detected - Canon imagePROGRAF iPF810 User Manual

Messages regarding paper

Paper size not detected.

Paper has been loaded askew, or warped paper has
been loaded.
662 Error Message
Cause Corrective Action
Follow these steps to reload the roll.
1.
Lift the Release Lever.
2.
Open the Top Cover.
3.
Adjust the right edge of the roll to make it parallel
to the right Paper Alignment Line.
4.
Lower the Release Lever.
5.
Close the Top Cover.
6.
If Not nished printing. Finish printing
remaining jobs? is shown on the Display Screen,
press the OK button.
Printing will resume, starting from the page on
which the error occurred.
(→P.139)
If this error recurs after you reload the roll, remove
the Roll Holder from the printer, push the roll rmly in
until it touches the Roll Holder ange, and reload the
Roll Holder in the printer.
(→P.136)
Follow these step to reload a sheet.
1.
Lift the Release Lever.
2.
Open the Top Cover.
3.
Adjust the right edge of the sheet to make it
parallel to the right Paper Alignment Line and the
trailing edge of the sheet to make it parallel to the
paper alignment line under the Paper Retainer.
4.
Lower the Release Lever.
5.
Close the Top Cover.
6.
If Not nished printing. Finish printing
remaining jobs? is shown on the Display Screen,
press the OK button.
Printing will resume, starting from the page on
which the error occurred.
(→P.164)