End Of Paper Feed; Rel Lever Is In Wrong Position; Rewinding Error; Media Take-Up Unit Ready - Canon imagePROGRAF iPF830 User Manual

End of paper feed.

Cause
There is a foreign object by
the Output Tray, obstructing
the Cutter Unit.
You are not using the printer
under the recommended en-
vironmental conditions for
the paper.
You are using paper that is
not compatible with auto-
matic cutting.
The Cutter Unit stops in the
middle of cutting.
In other cases, the Cutter
Unit may be damaged.
End of paper feed.
End of paper feed.
Although an attempt was made to advance the paper manually, it reached the limit
position that can be advanced.
Paper can be retracted only up to 17 mm (0.7 in) when using the Media Take-up
Unit.

Rel lever is in wrong position.

Rel lever is in wrong position.
Cause
The Release Lever is up.

Rewinding error.

Rewinding error.
There is some foreign object near the Media Take-up Unit
sensor and the roll cannot be detected.
The roll is out of range of detection by the Media Take-up
Unit sensor.
A paper jam has occurred and the roll cannot be rewound.
The Media Take-up Unit sensor is damaged.
646
*1:Printing will stop momentarily if an error involving the Media Take-up Unit occurs. If you prefer printing not to stop, set Skip
Take-Up Err to On. However, note that this error may cause paper jams and affect the printing quality.

Media take-up unit ready.

Media take-up unit ready.
The Take-up Reel setting in the printer Set./Adj. Menu
was changed from Enable to Disable, but a print job
was received before the roll was removed.
1.
Lift the Top Cover and remove the foreign object.
2.
If "Not finished printing. Finish printing remaining jobs?" is shown on the Display Screen,
press the OK button.
Printing will resume, starting from the page on which the error occurred.
Use the printer only where the recommended environmental conditions for the paper are met. Note
that various environmental conditions are recommended for various types of paper. For details on the
recommended environmental conditions for paper, see the Paper Reference Guide.
(See "Displaying the Paper Reference Guide.")
Specify Manual as the cutting method and cut the roll manually.
(See "Specifying the Cutting Method for Rolls.")
For information about paper that is compatible with automatic cutting, see the Paper Reference
Guide.
(See "Displaying the Paper Reference Guide.")
If the Carriage is out, move the Carriage out of the way, away from the paper.
If the Cutter is out, move the Cutter to the right side (away from the paper) and remove the jammed
paper.
(See "Clearing Jammed Roll Paper.")
If the paper cannot be cut using the Cutter Unit, specify Manual as the roll cutting method and cut the
roll manually.
(See "Specifying the Cutting Method for Rolls.")
Contact your Canon dealer for assistance.
Cause
Lower the Release Lever.
If the error occurs again, turn off the printer and wait a while before restoring power.
Cause
Cause
Corrective Action
P.323
➔
P.344
➔
P.323
➔
P.607
➔
P.344
➔
Canceling manual advancing.
(See "Feeding Roll Paper Manually.")
Canceling manual advancing.
Corrective Action
Corrective Action
Remove the foreign object near the sensor.
Reload the roll.
Press the OK button to clear the error.
(See "Loading Rolls in the Printer.")
(See "Loading the Rewind Spool on the Media Take-up Unit.")
Remove the paper from the Media Take-up Unit.
Press the OK button to clear the error.
Contact your Canon dealer for assistance.
Corrective Action
Press ▲ or ▼ to select Stop Printing, and then press the OK button to
stop printing.
iPF830
Corrective Action
P.341
➔
P.333
➔
P.367
➔
User's Guide