Setting the option output
This is set to flip/flop the option output.
Command to be used
1.
Move the needle to the desired position.
Refer to "Moving needle point" (page 123).
2.
Input the command for option output.
Ending programming
When programming is completed, input an end code.
Command to be used
1.
When the data is created, input the end code.
Data after the end code is input is deleted.
Flipping/flopping option output 1
Flipping/flopping option output 2
Flipping/flopping option output 3
Canceling option output setting
Normal end
Fixing the sewing speed at 1000 rpm or lower.
Carrying out no thread wiping.
Setting the sewing speed at 1000 rpm or lower without thread wiping.
Carrying out no thread trimming.
Fixing the sewing speed at 1500 rpm or lower.
Programmer
Chapter 3 Programming with Command Function
181