Chapter 2 Programming with Help Function
Canceling thread breakage at the last stitch
When "115" is input for the end code, the thread breakage does not occur. In this case, every
thread breakage including emergency stop is canceled. Carry out the following setting for
canceling thread breakage at the specified point.
Programming
1.
Create the program 1 stitch (A) before the
desired end point.
2.
Press
.
The number of pressing varies depending on the
programming method.
3.
Select
with
4.
Move the work clamp with
stitch length. Press
at point B of the pattern.
Point B is programmed.
5.
Press
.
82
Addition of feed after the last point can cancel thread
breakage at the last stitch.
and press
.
for the
when the needle point is
Programmer