CHAPTER 4 PROGRAMMING WITH COMMANDS
Low-speed sewing
Make setting for low-speed sewing.
Commands to be used
1. Move the needle to the position you want to
apply the command at.
For moving the needle position, refer to "Description
of commands" (page 90).
Setting the option output
This is set to flip/flop the option output.
Commands to be used
1. Move the needle to the position you want to
apply the command at.
For moving the needle position, refer to "Description
of commands" (page 90).
Setting the height of presser foot
The height of the presser foot is changed.
Command to be used
1. Input the height of the presser foot.
132
The maximum sewing speed is set at 400 rpm or lower.
The maximum sewing speed is set at 1200 rpm or lower.
The maximum sewing speed is set at 800 rpm or lower.
The maximum sewing speed is set at 600 rpm or lower.
Canceling low speed data setting
Flipping/flopping option output 1
Flipping/flopping option output 2
Flipping/flopping option output 3
Canceling option output setting
Input the height of the presser foot in
for input. Inputting
PD-3000
2. Select the type of low speed sewing and input
the command.
2. Input the command for option output.
. Height values of 0 to 99 are available
cancels setting for the height of presser foot