Resizing Input - Brother BAS-311F-0 Instruction Manual

Chapter 3 Programming with Command Function
Ending program
1. Press .

Resizing input

Programming
1. Press .
The work clamp moves to the home position and
the programmer screen is displayed.
2. Press
is the command for resizing input.
Input the magnification (02, 05, 10) in
3. Move the work clamp with
when the needle point is at point A of the
pattern.
The first stitch (point A) is programmed.
4. Repeat step 3 and create the program to point
D.
Inputting the end code
1. Press at the last stitch and press
.
The work clamp returns to the start position.
Saving
1. Specify the program number on the operation
panel and press the read/write switch for writing
into the floppy disk.
128
Resizing input is used to program a detailed pattern stitch by
stitch. The example in the left is used for explanation on of
programming the pattern to the magnification of 5.
.
. Press
.
Programmer