Setting Option Output No. To On Using Trigger Data During Sewing - Brother BAS-311E Option Manual

(option output No. 15: OFF). This is for checking the case that the output conditions of ON and
OFF are different.
•Prepare the programmer, and display the output setting screen.
‚Referring to the condition number table of machine operation mode (see page 191), set the option
output No. 15 to ON when the condition No. 2 (after the feed is completed at the sewing start
position) is set, Input on the setting screen as follows:
ƒMove the cursor to "ON", press the + key. ON, OFF, and F/F are switched every time the + key is
pressed. After setting "OFF", referring to the condition number table of machine operation mode
(see page 191), set the option output No. 15 to OFF when the condition No. 3 (before sewing start)
is set. Input on the setting screen as follows:
„After overwriting the option program to the FD, press the P key to turn off the display of the
programmer, and turn the power off and on again.
...Read the sewing data and carry out sewing. When the feed returns to the sewing start position,
check that the left work clamp rises, and descends at sewing start.
As shown in the above, when the timer 2 is "00", the option output number stays ON or OFF after
the condition is met.

2-4 Setting option output No. to ON using trigger data during sewing

No. 15 was set to ON at sewing start position in 2-2. The following procedure is to set No. 15 to
ON during sewing. For OFF setting, keep the setting of 2-3 so that No. 15 stays OFF at sewing
start.
•Read the written data with the FD read icon.
‚Referring to the condition number table of machine operation mode (see page 191), set the No. 15
to ON when the condition No. 14 (trigger data detection) is set. Input on the setting screen by
overwriting as follows:
5