Creating Double Stitch - Brother BAS-311F-0 Instruction Manual

Creating double stitch

Command to be used
If sharp angles or fine curves are included in the pattern sheet, the desired double stitch may not
be achieved.
1. Select the sewing start position with
2. Determine the width and input
3. Move the needle with
4. Move the needle to the corner point and input
Creating double stitch in the reverse direction to the sewing path. Input the
width of double stitch in
Values 1.0 - 9.9 mm are available for the width.
Example Width
1.5 mm
Input the stitch length in
Carrying out double stitch on the left side to the sewing path.
Carrying out double stitch on the right side to the sewing path.
Starting double stitch calculations.
(This is the end code. Refer to page 181 for details.)
to select the second point, then press
Programmer
Chapter 3 Programming with Command Function
.
Input
215
.
and press .
.
.
.
175