Lines - Brother BAS-311F-0 Instruction Manual

Ending program
1. Press .

Lines

Programming
1. Press .
The work clamp moves to the home position and
the programmer screen is displayed.
2. Move the work clamp with
when the needle point is at point A of the
pattern.
The first stitch (point A) is programmed.
3. Input the stitch length.
3.0 mm is input in the example.
Input 030 to make the stitch length to 3.0 mm.
4. Press .
To change the stitch length, specify the pitch value
before pressing
5. Move the work clamp with
when the needle point is at point B of the
pattern.
6. Repeat steps 4 and 5 and create the program to
point E.
Inputting the end code
1. Press at the last stitch and press
.
The work clamp returns to the start position.
The pattern with lines is programmed.
The example in the left is used for explanation of
programming.
. Press
.
. Press
Programmer
Chapter 3 Programming with Command Function
129