Brother BAS-311F-0 Instruction Manual page 51

Chapter 2 Programming with Help Function
2. Select with
3. Move the work clamp with
when the needle point is at point 1 of the
pattern.
The first stitch (point 1) is programmed.
4. Select with
5. Input the stitch length and the number of lines
for a multiple stitch. Press
"2.0 mm" is input for a stitch length in the
example.
Input "030" to make the stitch length to 3.0 mm.
To switch input between the stitch length and the
number of lines, use
6. Move the work clamp with
when the needle point is at point 2 of the
pattern.
7. Move the work clamp with
when the needle point is at point 3 of the
pattern.
Be sure to press
like point 3. If a split is not made, the corner will
be round.
8. Program the following points up to point 17 with
the curve programming steps.
When there is a liner section, move the needle
point from the split to the next split, and press
twice.
In the example, a linear line is programmed
between points 7 and 9. Be sure to program a
linear line also for the matched section between
points 24 and 26.
By pressing
the previous point. It cannot be returned beyond
the previous split.
By pressing
the previous split.
point is at a split, it cannot be moved.
By pressing
the split before the previous split.
9. Press . Move
. Press
at point 18 of the pattern.
50
and press .
and press
.
.
twice for a split at a corner
, the needle point is returned to
, the needle point is returned to
However, when the needle
, the needle point is returned to
the work clamp
when the needle point is
. Press
.
. Press
. Press
with
Programmer