Creating a circle (zigzag circle) by specifying the diameter
Command to be used
1.
Select the sewing start position with
2.
Input
3.
Input the stitch length in 3 digits and press
Creating a circle clockwise. Input the overlap stitch counts in
9 are available for input.
Creating a circle counterclockwise. Input the overlap stitch counts in
Values 0 - 9 are available for input.
Input this command to create a zigzag circle. Input the width of zigzag in
.
"Creating a circle (zigzag circle) by specifying 3 points"
(Refer to page 165.)
Input this command to create a zigzag circle. Input the zigzag stitch length
in
.
"Creating a circle (zigzag circle) by specifying 3 points" (Refer to page 165.)
or
.
and press
.
Programmer
Chapter 3 Programming with Command Function
.
Values 0 -
.
167