Removing And Installing The System Cover; Removing The System Cover; Installing The System Cover; Figure 15. Removing The Server System Cover - Intel SR1630BC - Server System - 0 MB RAM Service Manual

Removing and Installing the System Cover

Removing the System Cover

You must operate the server system with the system cover in place to ensure proper
cooling. You must remove the top cover to add or replace components inside of the server.
None of the internal components are hot-swappable. Before you remove the server system
cover, power down the server and unplug all peripheral devices and the AC power cable.
Note: You may need a non-skid surface or a stop behind the server system to prevent the server
system from sliding on your work surface.
1. Remove the top cover screw (see letter "A").
2. Remove the two screws at the front of the chassis (see letter "A" in the following
figure).
3. Loosen the screw at the rear of the chassis (see letter "B").
4. Push rearward on the blue grip point at the front of the server.
5. Slide the cover back until it stops and then lift the cover upward to remove it. See
letter "C".
6. Slide the cover back until it stops and lift the cover upward to remove it (see letter
"B").

Installing the System Cover

1. Observe the safety and ESD precautions at the beginning of this book. See
Information" on page
®
Intel Server System SR1630BC Service Guide

Figure 15. Removing the Server System Cover

-ix.
"Safety
25