Removing And Installing The Processor Air Duct; Removing The Processor Air Duct; Figure 16. Installing The Server System Cover - Intel SR1630BC - Server System - 0 MB RAM Service Manual

2. Place the cover over the server system so that the side edges of the cover sit just
inside the server system sidewalls. Slide the cover forward (see letter "A" in
Figure 16).
3. Tighten the screw at the rear of the server (see letter "B") and install the two screws
at the front of the server (see letter "C").

Removing and Installing the Processor Air Duct

The system requires the use of a processor air duct and power supply / electronics bay
isolation air baffle to direct airflow and sustain appropriate air pressure.
An air baffle isolates the air flow of the two power supply fans from that of the system fan
module. The baffle is mounted into three stand-offs with one end fitting under the back
edge of the hard drive bay.
Always operate your server system with the processor air duct in place. The air duct is
required for proper airflow within the server system.

Removing the Processor Air Duct

1. Observe the safety and ESD precautions at the beginning of this book. See
Information".
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Remove the server system cover. For instructions, see
Cover".
4. Lift the processor air duct from its location behind the two system blower fans.
26

Figure 16. Installing the Server System Cover

"Removing the System
®
Intel Server System SR1630BC Service Guide
"Safety