Replacing A Processor; Figure 27. Iu Reference Heat Sink Assembly - Intel SR1630BC - Server System - 0 MB RAM Service Manual

7. Reinstall and reconnect any parts you removed or disconnected to reach the
processor sockets.
8. Replace the server's cover and reconnect the AC power cord. See the docmentation
that came with your server chassis for instructions on installing the server's cover.

Replacing a Processor

1. Observe the safety and ESD precautions at the beginning of this book.
2. Turn off all peripheral devices connected to the server. Turn off the server.
3. Remove the AC power cord from the server.
4. Remove the server's cover.
5. Unplug the processor fan cable from the server board.
6. Loosen the four captive screws on the corners of the heat sink.
7. Twist the heat sink slightly to break the seal between the heat sink and the
processor.
8. Lift the heat sink from the processor. If it does not pull up easily, twist the heat sink
again. Do not force the heat sink from the processor. Doing so could damage the
processor.
9. Lift the processor lever.
10. Raise the CPU load plate.
®
Intel Server System SR1630BC Service Guide
CAUTION:
Do not
over-tighten
fasteners.
2
TIM

Figure 27. IU Reference Heat sink Assembly

3
1
4
35