Removing A Fixed Hard Disk Drive; Figure 32. Connecting Hard Drive Power And Data Cables - Intel SR1630BC - Server System - 0 MB RAM Service Manual

a. If a drive is installed in the HDD0 carrier, attach the middle connector on the

Removing a Fixed Hard Disk Drive

1. Disconnect the power and data cables from the drive.
2. HDD1 location only: Slide the power cable from the cable clip that is located on the
top of the hard drive carrier.
3. Remove the screw that holds the hard drive bracket to the chassis (see letter "A" in
the following figure). Save this screw. You will use it later to reinstall the drive
assembly. Lift the drive carrier from the chassis (see letter "B").
40
daisy chain power cable to the HDD0 power connector.
Figure 32. Connecting Hard Driver Power and Data Cables
®
Intel Server System SR1630BC Service Guide