Removing The Battery Pack - Contax I4R User Manual

Introduction

Removing the Battery Pack

1
Check that the camera is switched off
and then release the card/battery cover
latch.
qUse the pad of your finger to slide the card/battery cover in the
direction of the arrow until there is a click and the latch is released
(approximately 1 mm).
wThe bottom part of the card/battery cover opens (approximately
10 mm).
2
Open the card/battery cover.
ePull out the card/battery cover until it is stopped by the hinge.
rFully open the card/battery cover.
3
Rotate the battery stopper to unlock the
battery pack.
When you turn the catch in the direction of the arrow, the battery pack
pops out a small distance.
4
Grasp the battery pack and pull it out of
the camera.
A Important
BNote
Contents Glossary
Getting Ready Taking Pictures
• Take care that you do not drop the battery pack.
The strong impact of dropping the battery pack
may cause it to heat up or leak battery fluid.
• Depending on the operating conditions of the
camera, the battery pack may heat up. Be
careful when removing the battery pack from the
camera.
If you do not intend to use the battery pack for a
long period of time, store it in a cool environment.
Index
Playback
EN-26
Nomenclature
Set Up
2
Hinge
Battery Stopper
BACK NEXT
Menus and Settings Troubleshooting
1
4
3