Troubleshooting; Problems And Solutions - Contax I4R User Manual

Introduction

Troubleshooting

Check the items listed below before deciding that your camera is faulty.

Problems and Solutions

Problem
Nothing appears
on the LCD
monitor.
The LCD
monitor is blank.
There's no
image on the TV.
The number of
available shots
did not change
when I took a
picture.
I cannot erase
an image. "U"
icon displayed.
Contents Glossary
Getting Ready Taking Pictures
Cause
The batteries are flat, or the
Lithium Ion battery pack is
not inserted.
The Power Save function
has turned the camera off.
If you leave the camera for a
while without using it, the
camera goes into Sleep
mode.
There is something
generating a magnetic field
(such as a magnet or TV)
close to the camera.
A video cable is connected
to the USB cradle the
camera is placed in.
You are using the wrong
video output format.
This is because the
photographed image size
was small.
The image is protected.
Index
Playback
Insert the Lithium Ion battery
pack into the camera and
recharge the camera.
Turn the camera on again.
Press the shutter release button
half way or press any other
camera button to restore the
camera to Shooting mode. The
details vary depending on the
Power Save function settings.
Move the camera further away
from the magnetic object.
Disconnect the video cable from
the USB cradle.
Use the correct video output
format for the TV.
This is dependent on factors
such as the number of pixels
and the subject and is not a
problem.
Unprotect the image.
EN-186
Nomenclature
Set Up
Solution
Menus and Settings
Page
25
27
31
165
-
149
178
-
104
NEXT
Troubleshooting