Deleting The Device (Windows 98 And Windows 98Se Only) - Contax I4R User Manual

Introduction

Deleting the Device (Windows 98 and Windows 98SE only)

If the driver software is not installed successfully, the PC will be unable to
recognize the camera.
If this occurs, use the procedure below to delete the device. Then use the
procedure on p.135 to re-install the drivers.
* Note that this operation is only required for Windows 98 and Windows
98SE.
1
Insert the memory card into the camera.
( p.28)
2
Place the camera in the USB cradle and
connect the AC adapter.
BNote
3
Use the USB cable supplied with the camera to connect the
USB cradle holding the camera to the PC, then start the PC.
A Important
Contents Glossary
Getting Ready Taking Pictures
Refer to "Using the USB Cradle" (
details on attaching the USB cradle.
Check the sizes of the USB connectors. Plug the small connector into the USB cradle
and the large connector into the USB port on your PC.
Index
Playback
p.36) for
EN-142
Nomenclature
Set Up
BACK NEXT
Menus and Settings Troubleshooting