Viewing Images On A Macintosh - Contax I4R User Manual

Introduction

Viewing images on a Macintosh

A Important
• You do not need to install the USB drivers on a Macintosh computer. Connect the USB
• To view images on your Macintosh, you must have image-viewing software already
• Always use the AC adapter when you connect the camera to a computer to view and
1
Insert the memory card into the camera.
( p.28)
A Important
2
Place the camera in the USB cradle and
connect the AC adapter.
BNote
3
Use the USB cable supplied with the camera to connect the
USB cradle to the Macintosh and start the Macintosh.
A Important
Contents Glossary
Getting Ready
cable without installing the drivers.
installed. (To play movies, QuickTime 4.1 or later is required.)
copy images, etc. If the battery runs out and the camera turns off, files may be
corrupted.
You cannot view images on the Macintosh unless
there is a memory card in the camera.
Refer to "Using the USB Cradle" (
details on attaching the USB cradle.
Check the sizes of the USB connectors. Plug the small connector into the USB cradle
and the large connector into the USB port on your Macintosh.
Index
Taking Pictures Playback
p.36) for
EN-145
Nomenclature
Set Up
BACK NEXT
Menus and Settings Troubleshooting