Inserting The Battery Pack - Contax I4R User Manual

Introduction
Getting Ready

Inserting the Battery Pack

1
Releasing the latch on the card/battery
cover.
qUse the pad of your finger to slide the card/battery cover in the
direction of the arrow until there is a click and the latch is released
(approximately 1 mm).
wThe bottom part of the card/battery cover opens (approximately
10 mm).
2
Open the card/battery cover.
ePull out the card/battery cover until it is stopped by the hinge.
rFully open the card/battery cover.
3
Insert the battery pack (BP-760S)
supplied with the camera.
Turn the battery stopper at the end of the battery pack in the direction of
the arrow while inserting the battery pack, as shown in the illustration.
A Important
4
Close the card/battery cover.
Push the card/battery cover into the opening in the camera surface
while you close it, then slide it in the direction of the arrow until it clicks
and locks.
Make sure the hinge does not lift up as you close the cover.
Contents Glossary
Getting Ready Taking Pictures
• Insert the battery pack until the battery stopper
is securely locked (returns to its original
position).
• Be sure to insert the battery pack in the correct
direction, as inserting the battery pack the
wrong way around may cause damage.
Index
Playback
EN-25
Nomenclature
Set Up
2
Hinge
A
and B signs
Battery Pack Slot
Battery Stopper
Push against
the upper
surface.
NEXT
Menus and Settings Troubleshooting
1
4
3
Battery
Pack