Start Screen] Selecting The Startup Screen; To Set The Contax Logo Screen (Single/Multi) - Contax I4R User Manual

Introduction

[START SCREEN] Selecting the Startup Screen

Use this procedure to select one of the following as the startup screen that
is displayed when you turn the camera on:
• CONTAX logo (SINGLE)
• CONTAX logo (MULTI)
• User-defined screen (SINGLE) : You can choose an image from those saved on the memory card to display
• User-defined screen (MULTI) : You can choose multiple images from the memory card to display
• OFF screen
BNote
When you turn the power on, the camera runs a check on the memory card. If there is a lot
of data stored on the memory card, the startup screen is displayed until the check
operation is finished. If the camera is configured for a multi startup screen, the final frame
is displayed for an extended period after the animation has finished until the check
operation is finished.

To set the CONTAX logo screen (SINGLE/MULTI)

1
Turn the camera on and press the mode
button until "G" lights up on the mode
select LED.
The SET UP menu screen is displayed.
2
Press the 4-way button up or down to
select [START SCREEN], then press right.
Contents Glossary
Getting Ready Taking Pictures
: The CONTAX logo screen is displayed for approximately 1 second.
(Default)
: The CONTAX logo animation is displayed for approximately 1 second.
for approximately 1 second.
sequentially for approximately 1 second to form an animation. (up to 10
images)
: No startup screen is displayed.
Index
Playback
EN-170
Nomenclature
Set Up
SET UP(2/3)
BEEP +2
SHUTTER VOL +2
START SCREEN SET
REC REVIEW 2SEC
ENGLISH
LANGUAGE
VIDEO OUT NTSC
NEXT
Menus and Settings Troubleshooting