To Set A User-Defined Screen (Multi) - Contax I4R User Manual

Introduction

To set a user-defined screen (MULTI)

A Important
Check that the memory card containing the images you want to use is inserted into the
camera.
1
Turn the camera on and press the mode
button until "G" lights up on the mode
select LED.
The SET UP menu screen is displayed.
2
Press the 4-way button up or down to
select [START SCREEN], then press right.
3
Press the 4-way button up or down to
select [MULTI], then press the OK button
E.
4
Press the 4-way button left or right to
select the center location, then press
down.
The image selection screen appears showing the still images stored on
the memory card.
BNote
Contents Glossary
Getting Ready Taking Pictures
If you select [RESET], the reset confirmation
message appears. Select [EXECUTE] and press
the OK button E to delete the user-defined screen
set previously from the camera's memory.
Index
Playback
EN-173
Nomenclature
Set Up
SET UP(2/3)
BEEP +2
SHUTTER VOL +2
START SCREEN SET
REC REVIEW 2SEC
LANGUAGE ENGLISH
VIDEO OUT NTSC
SELECT START SCREEN
SINGLE
MULTI
OFF
SELECT START SCREEN
SELECT IMAGE
OK
BACK NEXT
Menus and Settings Troubleshooting
RESET