Contax I4R User Manual page 172

Introduction
3
Press the 4-way button up to select
[SINGLE], then press the OK button E.
4
Press the 4-way button left or right to
select the center location, then press
down.
The image selection screen appears showing the still images stored on
the memory card.
BNote
5
Press the 4-way button left or right to
select an image and press the OK button
E.
A message appears asking you to confirm the image setting.
6
Press the 4-way button up to select [SET],
then press the OK button E.
The selected image is stored in the internal camera memory.
The user-defined screen setting is set and the startup screen is
displayed for 1 second, and then the SET UP menu screen reappears.
BNote
• This setting is retained when you turn the camera off.
• Because the selected images are stored in the camera's memory, switching memory
Contents Glossary
Getting Ready
If you select [RESET], the reset confirmation
message appears. Select [EXECUTE] and press
the OK button E to delete the user-defined screen
set previously from the camera's memory.
cards or erasing the image from the memory card does not affect the images shown in
the startup screen.
Index
Taking Pictures Playback
EN-172
Nomenclature
Set Up
SELECT START SCREEN
SINGLE
MULTI
OFF
SELECT START SCREEN
SELECT IMAGE
OK
SELECT IMAGE
0001/0051
OK
APPLY SETTINGS?
SET
CANCEL
BACK NEXT
Menus and Settings Troubleshooting
RESET