Operating The Camera After Auto Off - Contax I4R User Manual

Introduction
2
Close the lens cover.

Operating the camera after auto off

This camera is fitted with a power-saving auto off function that
automatically turns the camera off if you leave it without performing any
operations. When the auto off function is activated, the LCD
monitor is cleared and the lens is retracted into the camera.
Use the following procedure to operate the camera after the auto off
function has been activated.
BNote
You can change the time setting of the auto off function. (
When you want to close the lens cover
Slide the lens cover once towards the outer edge until it stops (approximately 2 mm), then close the lens
cover.
A Important
When you want to turn the camera on again
Close the lens cover as described above.
Turn the camera back on by following the procedure on p.31.
Contents Glossary
Getting Ready Taking Pictures
If you close the lens cover directly, there is a risk of damaging the camera.
Index
Playback
EN-32
Nomenclature
Set Up
p.165)
BACK NEXT
Menus and Settings Troubleshooting