Table of Contents
Advertisement
2. Click the Scheduler Log tab in the right pane.
3. Right-click on the Scheduler Log page, and then point to Filter.
4. Select one of the data types that you want to see:
5. After you view the filtered log results, you can delete the entire
Refreshing the log
A scan might have started while you were looking at the Scheduler settings,
adding new data to the log since you opened the Scheduler window. You can
set a refresh frequency for the log, let it use its default auto refresh setting, or
refresh the log on demand.
Follow these steps to refresh the log:
1.
2. Click the Scheduler Log tab in the right pane.
The Scheduler Log page appears
You can filter your view of the log information. Each line of information
is prefixed by an icon, denoting its type.
Errors. Select this filter type to view only those scans in which an
error occurred, such as a virus was detected or a scan failed to start.
Info. Select this filter type to view only information about changes
and setups made to scan events.
Successes. Select this filter type to view only the scans that started
successfully and found no viruses.
All. Select this filter type to view all three types of information.
scheduled-scan result log. Right-click in the Scheduler Log page, and
choose Delete entire log to erase all entries in the whole log, not just the
filtered results.
An hourglass icon appears in front of the Schedule icon
has been deleted.
Under the Management Server for the anti-virus domain, click
Schedule.
The Scheduler Events page appears in the right pane
118).
The Scheduler Log page appears
(Figure 4-6 on page
(Figure 4-14 on page
(Figure 4-6 on page
Administrator's Guide
Creating Schedules
103).
until the log
103).
119
Advertisement
Table of Contents
