McAfee MANAGEMENT EDITION 2.5 Administrator's Manual page 48

Installing the Management Edition Program
Preparing for the NetShield program rollout on NetWare servers
Management Edition configures only the on-access scanner settings and sets
the other settings to the defaults; you will need to configure these settings with
the NetShield NetWare NT Console by connecting to the NetWare servers
individually, prior to rollout. The settings are stored in a file called
NETSHLD.REG, in which you can customize settings that were not configured
by the Management Edition program (see
program install options and on-access scanner settings on NetWare
È
After the initial installation of the NetShield program to the NetWare server,
the NetShield NetWare NT Console password required to connect to the
NetWare server is set to "NetShield." You must change this password from the
NetShield NetWare NT Console. The Management Edition configuration
.DLL cannot do this at present; however, the password is stored in a file called
PASSWORD.PWD, a customized version of which can be place in the
Repository.
Customizing the NetShield program install options and
on-access scanner settings on NetWare servers
The Management Edition configuration .DLL starts off with a version of the
NETHSHLD.REG file that has the defaults for the settings that it does not set.
It then applies its settings for the on-access scanner and the NetShield
NetWare installation directory before rolling out to individual servers. The file
is in binary format, so it cannot be edited by hand. However, you can
customize the NETSHLD.REG file with the default settings you want by using
the following method.
Follow these steps:
1. Roll out the NetShield program to the NetWare server using the default
2. Start the NetShield NetWare NT Console on a Windows NT workstation
48 Management Edition
IMPORTANT: After the initial rollout of the Management Edition
program, if you change settings with the NetShield NT Console, the
Management Edition program will not know about these changes. The
next time you roll out new settings with the Management Edition
program, the settings will be lost (they will revert to defaults). Either use
the Management Edition program for the initial rollout only, or use a
customized NETSHLD.REG with the settings you want for all of the
servers (see "Customizing the NetShield program install options and
on-access scanner settings on NetWare
settings.
and connect to the NetWare server.
"Customizing the NetShield
servers").
servers").