McAfee MANAGEMENT EDITION 2.5 Administrator's Manual page 77

Creating Anti-virus Domains
Before the Management Agent can locate a Name Provider to request a
computer name, it must be given the name of the anti-virus domain it is to join.
You can configure this within the NAMEPROV.INI file before the installer
runs, or afterwards, when the Management Agent will request it.
The installation process is normally completely silent. If an error occurs, a
message appears.
This is the basic template NAMEPROV.INI file, as supplied with the installer:
; This is the section header that needs to be used. This
; is mandatory.
[NameProv]
; NP_DOMAIN is the name of the AV domain that this name
; provider is located in.
; This entry is mandatory.
;NP_DOMAIN=A_DOMAIN
; NP_PARTIAL can be used to allocate a given prefix to new
; computers that need the services of the name provider.
; The text entered will prefix a number generated by the
; name provider e.g. SALES_000042.
; NP_PARTIAL has a maximum length of ten characters.
; This entry is optional.
;NP_PARTIAL=SALES
; NP_ADDR1 and NP_ADDR2 hold the addresses of the machine
; that the name provider is located on. Specify either IP
; or IPX. If you only want to specify a single address,
; then you must use NP_ADDR1.
; These entries are optional. The format is #IP#<address>,
; where <address> is an IP address in decimal notation
; (a.b.c.d), or #IPX#<network>:<node>, where <network> is
; the IPX network segment address that the machine resides
; on and <node> is the machine's IPX node address.
;NP_ADDR1=#IP#192.168.1.2
;NP_ADDR2=#IPX#10a2:0020AFB4B76B
; NP_COMMENT is the comment associated with the machine.
; This entry is optional.
;NP_COMMENT=Machine comment
Administrator's Guide 77