Automatic Positioning Of Rotary Axes - HEIDENHAIN ITNC 530 - CYCLE PROGRAMMING User Manual

Automatic positioning of rotary axes

If the rotary axes are positioned automatically in Cycle 19:
The TNC can position only controlled axes
In order for the tilted axes to be positioned, you must enter a feed
rate and a setup clearance in addition to the tilting angles, during
cycle definition.
Use only preset tools (the full tool length must be defined).
The position of the tool tip as referenced to the workpiece surface
remains nearly unchanged after tilting.
The TNC performs the tilt at the last programmed feed rate. The
maximum feed rate that can be reached depends on the complexity
of the swivel head or tilting table.
Example NC blocks:
10 L Z+100 R0 FMAX
11 L X+25 Y+10 R0 FMAX
12 CYCL DEF 19.0 WORKING PLANE
13 CYCL DEF 19.1 A+0 B+45 C+0 F5000 SETUP50
14 L Z+80 R0 FMAX
15 L X-8.5 Y-10 R0 FMAX
294
Define the angle for calculation of the compensation
Also define the feed rate and the clearance
Activate compensation for the spindle axis
Activate compensation for the working plane
Cycles: Coordinate Transformations