Table of Contents
Advertisement
7.7 FLOOR FINISHING (Cycle 23,
DIN/ISO: G123)
Cycle run
The tool approaches the machining plane smoothly (on a vertically
tangential arc) if there is sufficient room. If there is not enough room,
the TNC moves the tool to depth vertically. The tool then clears the
finishing allowance remaining from rough-out.
Please note while programming:
The TNC automatically calculates the starting point for
finishing. The starting point depends on the available
space in the pocket.
The approaching radius for pre-positioning to the final
depth is permanently defined and independent of the
plunging angle of the tool.
Cycle parameters
U
Feed rate for plunging Q11: Traversing speed of the
tool during plunging. Input range 0 to 99999.9999,
alternatively FAUTO, FU, FZ
U
Feed rate for roughing Q12: Milling feed rate. Input
range 0 to 99999.9999, alternatively FAUTO, FU, FZ
U
Retraction feed rate Q208: Traversing speed of the
tool in mm/min when retracting after machining. If
you enter Q208 = 0, the TNC retracts the tool at the
feed rate in Q12. Input range 0 to 99999.9999,
alternatively FMAX, FAUTO, PREDEF.
198
Example: NC blocks
60 CYCL DEF 23 FLOOR FINISHING
Q11=100
;FEED RATE FOR PLNGNG
Q12=350
;FEED RATE FOR ROUGHING
Q208=99999 ;RETRACTION FEED RATE
Fixed Cycles: Contour Pocket, Contour Trains
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the ITNC 530 - CYCLE PROGRAMMING and is the answer not in the manual?
Questions and answers
Can I change the approach direction when cycle def a stud to avoid obstruction to the right
The provided context does not explicitly mention changing the approach direction to avoid obstruction. However, it describes selecting different axis configurations using the MOD function in the Programming and Editing mode. If modifying the axis configuration allows for adjusting the approach direction, it may be possible. Otherwise, specific cycle parameters should be checked in the programming manual.
This answer is automatically generated