Table of Contents
Advertisement
16.1 Fundamentals
Overview
The TNC offers twelve cycles for measuring workpieces
automatically.
Cycle
0 REFERENCE PLANE Measuring a
coordinate in a selectable axis
1 POLAR DATUM PLANE Measuring a
point in a probing direction
420 MEASURE ANGLE Measuring an
angle in the working plane
421 MEASURE HOLE Measuring the
position and diameter of a hole
422 MEAS. CIRCLE OUTSIDE
Measuring the position and diameter of
a circular stud
423 MEAS. RECTAN. INSIDE Measuring
the position, length and width of a
rectangular pocket
424 MEAS. RECTAN. OUTSIDE
Measuring the position, length and
width of a rectangular stud
425 MEASURE INSIDE WIDTH (2nd
soft-key row) Measuring slot width
426 MEASURE RIDGE WIDTH (2nd soft-
key row) Measuring the width of a ridge
427 MEASURE COORDINATE (2nd soft-
key row) Measuring any coordinate in a
selectable axis
430 MEAS. BOLT HOLE CIRC. (2nd soft-
key row) Measuring position and
diameter of a bolt hole circle
431 MEASURE PLANE (2nd soft-key
row) Measuring the A and B axis angles
of a plane
396
Soft key
Page
Page 402
Page 403
Page 405
Page 408
Page 412
Page 416
Page 420
Page 424
Page 427
Page 430
Page 433
Page 437
Touch Probe Cycles: Automatic Workpiece Inspection
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the ITNC 530 - CYCLE PROGRAMMING and is the answer not in the manual?
Questions and answers
Can I change the approach direction when cycle def a stud to avoid obstruction to the right
The provided context does not explicitly mention changing the approach direction to avoid obstruction. However, it describes selecting different axis configurations using the MOD function in the Programming and Editing mode. If modifying the axis configuration allows for adjusting the approach direction, it may be possible. Otherwise, specific cycle parameters should be checked in the programming manual.
This answer is automatically generated