Table of Contents
Advertisement
Cycle parameters
U
Axis and scaling factor: Select the coordinate
axis/axes by soft key and enter the factor(s) involved
in enlarging or reducing. Input range: 0.000000 to
99.999999
U
Center coordinates: Enter the center of the axis-
specific enlargement or reduction. Input range:
-99999.9999 to 99999.9999
HEIDENHAIN iTNC 530
Example: NC blocks
25 CALL LBL 1
26 CYCL DEF 26.0 AXIS-SPECIFIC SCALING
27 CYCL DEF 26.1 X 1.4 Y 0.6 CCX+15 CCY+20
28 CALL LBL 1
289
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the ITNC 530 - CYCLE PROGRAMMING and is the answer not in the manual?
Questions and answers
Can I change the approach direction when cycle def a stud to avoid obstruction to the right
The provided context does not explicitly mention changing the approach direction to avoid obstruction. However, it describes selecting different axis configurations using the MOD function in the Programming and Editing mode. If modifying the axis configuration allows for adjusting the approach direction, it may be possible. Otherwise, specific cycle parameters should be checked in the programming manual.
This answer is automatically generated