Table of Contents
Advertisement
6 L X+10 Y+10 R0 FMAX M3
7 CYCL CALL
8 L Y+90 R0 FMAX M99
9 L X+90 R0 FMAX M99
10 L Y+10 R0 FMAX M99
11 L Z+250 R0 FMAX M2
12 END PGM C200 MM
102
Approach hole 1, spindle ON
Cycle call
Approach hole 2, call cycle
Approach hole 3, call cycle
Approach hole 4, call cycle
Retract in the tool axis, end program
Fixed Cycles: Drilling
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the ITNC 530 - CYCLE PROGRAMMING and is the answer not in the manual?
Questions and answers
Can I change the approach direction when cycle def a stud to avoid obstruction to the right
The provided context does not explicitly mention changing the approach direction to avoid obstruction. However, it describes selecting different axis configurations using the MOD function in the Programming and Editing mode. If modifying the axis configuration allows for adjusting the approach direction, it may be possible. Otherwise, specific cycle parameters should be checked in the programming manual.
This answer is automatically generated