Table of Contents
Advertisement
New Cycle Functions of Software
340 49x-06
New Cycle 275 "Trochoidal Contour Slot"(see "TROCHOIDAL SLOT
(Cycle 275, DIN/ISO: G275)" on page 205)
In Cycle 241 "Single-Fluted Deep-Hole Drilling" it is now possible to
define a dwell depth (see "SINGLE-FLUTED DEEP-HOLE DRILLING
(Cycle 241, DIN/ISO: G241)" on page 98)
The approach and departure behavior of Cycle 39 "Cylinder Surface
Contour" can now be adjusted (see "Cycle run" on page 230)
New touch probe cycle for calibration of a touch probe on a
calibration sphere (see "CALIBRATE TS (Cycle 460, DIN/ISO:
G460)" on page 458)
KinematicsOpt: An additional parameter for determination of the
backlash in a rotary axis was introduced (see "Backlash" on page
473)
KinematicsOpt: Better support for positioning of Hirth-coupled axes
(see "Machines with Hirth-coupled axes" on page 469)
14
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the ITNC 530 - CYCLE PROGRAMMING and is the answer not in the manual?
Questions and answers
Can I change the approach direction when cycle def a stud to avoid obstruction to the right
The provided context does not explicitly mention changing the approach direction to avoid obstruction. However, it describes selecting different axis configurations using the MOD function in the Programming and Editing mode. If modifying the axis configuration allows for adjusting the approach direction, it may be possible. Otherwise, specific cycle parameters should be checked in the programming manual.
This answer is automatically generated